10/100 Base-TX LANJack RJ45 Single Port without LED	10/100 Base-TX LANJackRJ45 Single Port with LED Tap up and Tap down
1000 Base-TX LANJack RJ45 Single Port with LED	10/100 Base-TX LANJack 1000 Base-TX LANJack RJ45 Single Port Low Profile with LED
10/100 Base-TX LANJack 1000 Base-TX LANJack RJ45 Dual USB	10/100 Base-TX LANJack Multiport
1000 Base-TX LANJACK Multiport Stacked 2*1

• Reduce costs for manufacturers due to the combining of two components into one
• Reduce PCB space for better EMI performance and signal integrity than discrete solution
• Require less board space than discrete option
• Meet or exceed IEEE 802.3 and ANSI X3.263 standards
• Designed for transmission over CAT 5 or CAT 6 cable
• Minimum of 1,500 Vrms for 1 minute hipot isolation
• Operating temperatures range from 0°C to 70°C

FALCO offers the complete line of LANJack for PC motherboards, Access Points, Gaming Systems, LAN connected UPS’s, Routers, IP Phones, Data Acquisition Systems, Modems and other Network Devices from 10/100 Mbps to 1000 Mbps both with and without USB ports. Most of LANJack with dual USB products are USB 2.0 compliant. Falco also offers lead free, Auto MDI/MDIX, TVS protection and Power over Ethernet LANJacks.

Falco’s LANJacks are compatible with auto-insertion manufacturing processes. These connectors are confirgured as shielded designs with integrated magnetic and light emitting diodes (LED) are included in most models.

An integrated connector as opposed to the traditional discrete solution, brings both electrical efficiency and space saving benefits to the LAN circuit on the PC motherboard or the Network Devices and allows for a better control of the differential pair traces impedance and thus improves the signal integrity as well as EMI performance of the system. All connectors have passed IEEE802.3 and signal integrity requirements for major IC manufacturers.

PHY TRANCEIVER CHIPS COMPATIBILITY

Our design team in Los Angeles, USA can accommodate specific schematic design needs for your particular applications.

APPLICATIONS

Data networking utilizes Unshielded Twisted Pair (UTP) as a transmission medium which is prone to noise pickup that leads to conducted and radiated noise emission. Therefore the magnetic filter is a must for the LAN system to pass FCC and signal integrity requirements.

Connector with integrated magnetics are required for impedance matching, signal shaping and conditioning, high voltage isolation and common mode noise reduction and used in virtually in all internet and LAN interface devices including high end servers, network interface cards (NIC), local area network card on motherboard (LOM), hubs, switches and routers.